Air batch is one of the production tools of air tool manufacturers, air batch is run with compressed air as a power, mainly used for various assembly work, the mode of operation are respectively press type, hand press type. Check and maintain before and after use. So in the process of use, there may be a phenomenon of wind batch weakness, what is the reason for this phenomenon?
There are 4 common reasons for the weakness of air tools manufacturers:
The consumables are worn away, and the blades, bearings and other consumables need to be replaced in order to restore the strength;
Insufficient air pressure, even if it is a small 5H air batch, it is required that the air pressure can be maintained between 6-6.5kg-cm when used, so that the machine can play its normal capacity;
For example, the 5H air batch capacity is 3-5mm screw diameter, the length of the screw does not exceed 50mm, and the air pressure is enough to play the machine capacity normally. But if you take 5H wind batch to play very long, or 6mm or even larger screws, hit the hardwood, the performance must be powerless, can not go down, or play half of the situation;
Air tool manufacturers recommend that the air strike structure is damaged, which should replace the hammer block, spindle, CAM and other strike structures.
Air batch is commonly known, the standard should be called: pneumatic screwdriver. Due to the relationship between the southern local name habit, the manually screwed screwdriver is often called "screw batch", and then there is a pneumatic screwdriver, which uses compressed air to do power, which is referred to as "wind batch". Just as the north is used to calling the screwdriver "screwdriver" and "screwdriver", the later pneumatic screwdriver, the North is also used to calling it "pneumatic screwdriver" and "pneumatic screwdriver".






