PROITON pneumatic tool is mainly a tool that uses compressed air to drive the pneumatic motor and output kinetic energy to work, then what is the maintenance method in the process of using PROITON pneumatic tool?
1, the correct replacement air supply system: the intake pressure at the tool entrance (non-air compressor air pressure) is generally 90PSIG(6.2Kg/cm^2), too high, too low are harmful to the performance and life of the tool. The intake air should contain sufficient lubricating oil so that the air motor inside the tool can be fully lubricated (you can place a piece of white paper at the exhaust of the tool to check whether there is oil stains, normally there is oil stains). The intake air is as free of water as possible, and it is inappropriate to shrink the air without using the air dryer.
2, can not arbitrarily remove the parts of the tool after the operation, in addition to affecting the operator's safety will cause damage to the tool.
3, if the tool is slightly faulty or can not reach the original function, can not continue to use, to check immediately.
4, regularly (about once a week) check, maintenance tools, add butter (Grease) to bearings and other rotating parts, add Oil (Oil) to the air motor parts.
5, use all kinds of tools, be sure to follow all kinds of safety regulations and instructions to operate.
6, to choose the appropriate tools to work, the tool is too large easy to cause work damage, the tool is too small easy to cause tool damage.






